Wollongong guide

Dual occupancy in Wollongong.

Since July 2024, dual occupancy has been permissible in every R2 zone in NSW. Whether your block qualifies comes down to a handful of site tests. Here is how to run them.

Book a free consultation Call 0410 752 616
01Building designer, BDAA member
0220+ years designing homes
03Design, approvals and documentation

By Jay Francis, building designer and director of Francis Design. Updated 25 October 2026.

A dual occupancy is two dwellings on one lot of land. The homes can be attached, which is what most people call a duplex, or detached, as two separate houses sharing the lot. For Wollongong owners and investors it is the most common way to add a second home without buying more land, and it is often paired with a knockdown rebuild of the existing house.

The question we hear most is simple: will council let me do it here? The answer comes from the planning controls on your specific lot, not from what a neighbour built, so this guide sets out the tests in the order we check them.

Dual occupancy, duplex, dual key or granny flat?

  • Attached dual occupancy (duplex): two homes sharing a common wall, each with its own entry, kitchen and private open space. It can be subdivided on Torrens or strata title where the controls allow.
  • Detached dual occupancy: two separate buildings on one lot, often front-and-back on a deep block, or one facing each street on a corner lot.
  • Dual key: one building with two self-contained homes behind a shared entry, usually on a single title. Popular for multigenerational living and rental flexibility.
  • Secondary dwelling (granny flat): a second home of up to 60 square metres under the Housing SEPP, which cannot be subdivided from the main house. Simpler and cheaper, but it is not a dual occupancy.

If you never intend to subdivide or sell separately, a granny flat may be all you need; see our granny flat design page. If the goal is two homes that can be sold separately, it has to be a dual occupancy.

Zoning and lot tests under the Wollongong LEP and Housing SEPP

Start with the zone. Since 1 July 2024 dual occupancy has been permissible with consent in the R2 Low Density Residential zone across NSW, and it is allowed in other residential zones where the Wollongong Local Environmental Plan 2009 permits it. The section 10.7 planning certificate for your lot confirms the zone and the overlays that apply.

Next, check whether the lot is in a mapped Low and Mid-Rise Housing area, within about 800 metres walk of a nominated town centre or station. In those areas the Housing SEPP sets standards that council cannot use to refuse a dual occupancy that meets them:

  • Minimum lot size of 450 square metres
  • Minimum lot width of 12 metres
  • Maximum floor space ratio of 0.65:1
  • Maximum building height of 9.5 metres
  • One car space per dwelling

Outside the mapped areas, the Wollongong LEP and DCP controls for lot size, frontage, floor space and landscaping apply instead. Either way, bushfire-prone land, heritage items and some flood-affected land change the answer, so read the planning certificate before any rule of thumb.

Site constraints that decide a dual occupancy in the Illawarra

  • Slope: a lot that falls away from the street may need a stormwater easement through a downhill neighbour, or an engineered on-site system, before a second dwelling can drain.
  • Escarpment land: land identified for slope instability needs geotechnical assessment under Chapter E12 of the Wollongong DCP.
  • Bushfire: bushfire-prone land needs a Bushfire Attack Level assessment under Planning for Bush Fire Protection and AS 3959, and may need a DA.
  • Flood and coastal: flood planning levels on the coastal plain can set minimum floor levels for both homes.
  • Sewer and easements: a Sydney Water main through the yard can move a rear dwelling or rule it out.
  • Access and parking: both homes need workable driveways, bin storage and car turning, which is where many narrow lots fail.

Our site feasibility check runs these tests before you commit to design.

Approval routes: CDC under the Low Rise Housing Diversity Code, or a DA

A dual occupancy that meets every standard of the Low Rise Housing Diversity Code in the Codes SEPP can be approved as complying development through a CDC, issued by council or a registered certifier, without a merit assessment. Designs that need flexibility, and sites with heritage, flood or higher bushfire risk, go to Wollongong City Council as a development application lodged through the NSW Planning Portal.

Subdivision can be approved in the same application or separately. For Torrens title each new lot needs its own services, and Sydney Water issues a Section 73 compliance certificate before the subdivision certificate and new titles are released. Our duplex design guide compares Torrens and strata title in more detail.

From approved plans to two finished homes in Wollongong

Once the design is approved and documented, the build is one construction project delivering two homes, usually with subdivision works running alongside. Two dwellings mean two sets of services, two BASIX certificates and more coordination than a single house, which is why the builder's experience with this building type matters as much as the price.

If you are comparing builders, look for proven dual occupancy construction in Wollongong: completed attached and detached projects, a site assessment before you spend on design, and a clear view on Torrens or strata from the start. Owners and builders can also engage us directly for the design, approvals and documentation through our dual occupancy design service.

FAQs

Common questions.

Is dual occupancy allowed in R2 zones in Wollongong? +

Yes. Since 1 July 2024 dual occupancy has been permissible with consent in R2 Low Density Residential zones across NSW, including Wollongong. Each proposal still has to meet the lot, design and overlay controls that apply to the site.

What is the minimum lot size for a dual occupancy? +

In mapped Low and Mid-Rise Housing areas the Housing SEPP sets a 450 square metre minimum lot size and a 12 metre minimum width. Elsewhere the Wollongong LEP and DCP controls apply, so check the planning certificate for your lot.

What is the difference between a dual occupancy and a granny flat? +

A granny flat is a secondary dwelling of up to 60 square metres that stays on the same title as the main house. A dual occupancy is two full dwellings, which can usually be subdivided and sold separately where the controls allow.

Can I live in one home and rent or sell the other? +

Yes, and it is one of the most common reasons to build a dual occupancy. To sell one home separately you need a Torrens or strata subdivision, so plan the title before design starts.

Can a dual occupancy be approved with a CDC? +

Yes, where the site and design meet every standard in the Low Rise Housing Diversity Code. If any standard is not met, the project needs a development application.

Does a sloping block rule out a dual occupancy? +

No, but it changes the design and the cost. Stormwater, retaining, access and geotechnical requirements all need to be resolved early.

Related concepts

Plain-English definitions in our building design glossary.

Next Step

Find out what your block can do.

Book a free consultation with Francis Design to test your block, compare layouts and plan the approval pathway before you commit to a builder.

Free Consultation

Send a quick enquiry

Share a little about your project and Jay will come back with a tailored next step.

Call Now Book Consult